Installer Settings; Source Volume Switch - JBL PSB-1 Owner's Manual

Installer Settings

This section contains advanced settings intended only for the installer. Once the appropriate settings are chosen, the
Rear Security Plate (included) can be installed with a screw (included) to prevent end-users from tampering with these
critical settings.

SOURCE VOLUME SWITCH

This 2-position switch allows the installer to select the desired volume
control scheme (see "Volume Control Schemes" on page 2). When
designing a TV-plus-soundbar system, one must decide where to control
volume: at the source (i.e. the TV) or at the soundbar. While each scheme
has its own merits, the JBL
accommodate either scenario for maximum flexibility.
"Variable Source" (fixed soundbar)
Select this position if volume is being controlled at the TV. In this
mode of operation, the TV sends volume-adjusted audio levels to the
soundbar, which itself maintains a fixed volume level. In this mode, the
end user can adjust volume via the following user interfaces:
• The existing remote control that came with the TV
• A third party universal remote control configured to control the TV's volume
• The buttons built into the TV
"Fixed Source" (variable soundbar)
Select this position if volume is being controlled at the soundbar. In this mode of operation, the TV sends fixed
audio levels to the soundbar, where volume is then adjusted. In this mode, the end user can adjust volume via the
following user interfaces:
• The existing remote control that came with the TV (see "Programming the Soundbar to Respond to Any
Remote" on page 9)
• A third party universal remote control configured to control the PSB-1's volume (see "Programming a
Universal Remote to Control the Soundbar" on page 11)
• The soundbar's remote control (included)
• The buttons built into the soundbar
PSB-1 Owner's Manual
Installer Settings
Professional SoundBar PSB-1 is designed to
®
Source Volume Switch
Page 5