Bicker eNSP3-450P-USB User Manual page 35

User's Manual eNSP3-450P-RS / eNSP3-450P-USB
3
The following connections have
to be made at the PCB:
Connect the red-and-black twisted cable to +5 V and the purple-and-black twisted cable to +5 VS.
Observe polarity!
Then, connect the open ends to the ATX cable harness (red/red, purple/purple, black/black).
Connect the start button of the PC to OUT2 and connect the included black-and-white cable to the
multi-pin connector (= start button) on the motherboard. Connect the remaining connector to OUT1.
Power Supply
Crimp Connector
+5 V
sb
+5 V
GND
– +
+5 V
PS2637
OUT2
Start-Button
Multi-pin connector
Motherboard
– +
+5 VS
OUT1
multi-pin
connector
On / Off
35