Connection Module; Installing The Audio Equipment; I/O Inputs And Outputs; Video Out - Axis 213 PTZ User Manual

Connection Module

The connection module connects to the camera and is configured and controlled via
the camera's user interface. The Connection module is an optional accessory
providing the following:
• audio in / out
• 3 relay outputs
• 2 digital inputs

Installing the audio equipment

1. Connect a microphone (not supplied) to the Audio IN socket.
2. Connect a loudspeaker (not supplied) to the Audio OUT socket (amplified
speakers only).

I/O inputs and outputs

The I/O inputs / outputs are used in applications for, e.g. event triggering, time lapse
recording, alarm notification via email, picture storage to FTP locations.
• Input - e.g. a doorbell. If the doorbell is pressed, the state changes, and the input
will be active (shown under Event Configuration | Port Status).
• Output - e.g. an alarm device that can be activated from Output buttons from the
Live View page or as an action to an Event Type. The output will show as active
(under Event Configuration | Port Status), if the alarm device is activated.
I/O
Alarm In 1,2
Alarm GND
Alarm Out
1A,1B;2A,2B;3A,3B

Video Out

Via a standard BNC connector, this output allows the AXIS 213 to be connected
directly to traditional CCTV systems.
Video In and RS-232C can be configured under Plain config for use in advanced
applications (see System Options | Advanced | Plain Config). Intended for advanced
users only.
Description
Connect to GND to activate or leave floating (unconnected) to deactivate
Active output, electrical connection between A and B. Non active output, no
connection between A and B. Imax=100mA, VMax=24V
AXIS 213 - Connection Module
• video in / out
• RS-232C Serial port
43