Direct Devices Status; Iec 61850 Goose Integers; Teleprotection Channel Tests - GE L60 Instruction Manual

6 ACTUAL VALUES

PATH: ACTUAL VALUES STATUS
 DIRECT DEVICES
 STATUS
MESSAGE
MESSAGE
These actual values represent the state of direct devices 1 through 16.

PATH: SETTINGS INPUTS/OUTPUTS
 GOOSE UINTEGER
 INPUT 1
MESSAGE
The IEC 61850 GOOSE uinteger inputs feature allows the transmission of FlexInteger values between any two UR-series
devices. The following settings are available for each GOOSE uinteger input.
• UINTEGER 1 DEFAULT: This setting specifies the value of the GOOSE uinteger input when the sending device is
offline and the
UINTEGER 1 DEFAULT MODE
number.
• UINTEGER 1 DEFAULT MODE: When the sending device is offline and this setting is "Last Known", the value of the
GOOSE uinteger input remains at the last received value. When the sending device is offline and this setting value is
"Default Value", then the value of the GOOSE uinteger input is defined by the
The GOOSE integer input FlexInteger values are available for use in other L60 functions that use FlexInteger values.

PATH: ACTUAL VALUES STATUS
 TELEPROT CH TESTS

MESSAGE
MESSAGE
MESSAGE
MESSAGE
The status information for two channels is shown here.
• CHANNEL 1 STATUS: This represents the receiver status of each channel. If the value is "OK", teleprotection is
enabled and data is being received from the remote terminal; If the value is "FAIL", teleprotection enabled and data is
not being received from the remote terminal. If "n/a", teleprotection is disabled.
GE Multilin


DIRECT DEVICES STATUS

DIRECT DEVICE 1
STATUS: Offline
DIRECT DEVICE 2
STATUS: Offline
↓
DIRECT DEVICE 16
STATUS: Offline

IEC 61850 GOOSE UINTEGERS
UINTEGER 1 DEFAULT:
1000
UINTEGER 1 DEFAULT
MODE: Default Value
is set to "Default Value".This setting is stored as a 32-bit unsigned integer

TELEPROT CH TESTS
CHANNEL 1
STATUS: n/a
CHANNEL 1 LOST
PACKETS: 1
CHANNEL 2
STATUS: n/a
CHANNEL 2 LOST
PACKETS: 1
VALIDITY OF CHANNEL
CONFIGURATION: FAIL
L60 Line Phase Comparison System
6.2.16 DIRECT DEVICES STATUS
Range: Offline, Online
Range: Offline, Online
Range: Offline, Online

6.2.17 IEC 61850 GOOSE INTEGERS


GOOSE UINTEGER INPUT 1(16)
Range: 0 to 429496295 in steps of 1
Range: Default Value, Last Known
UINTEGER 1 DEFAULT

6.2.18 TELEPROTECTION CHANNEL TESTS

Range: n/a, FAIL, OK
Range: 1 to 65535 in steps of 1
Range: n/a, FAIL, OK
Range: 1 to 65535 in steps of 1
Range: n/a, FAIL, OK
6.2 STATUS
6
setting.
6-9