Playing Back Sources From Other Devices - JVC CA-NXBD3 Instruction

Playing back sources from
other devices
AUX
ENTER
CAUTION
Slide the remote control mode selector
to [AUDIO].
Selecting other devices as the
source
1
Remote
control
mode
selector
2
3
Selecting the signal gain
You can select the gain of the signal from the
[AUDIO IN] terminals.
Use the initial settings for normal operation. If the
sound is too soft or too loud, change the settings.
1
2
3
Press [AUX].
Each time you press [AUX], the display changes
in the display window as follows.
• "AUDIO IN" for selecting the device connected
to the [AUDIO IN] terminal.
• "DIGITAL IN" for selecting the device
connected to the [DIGITAL IN] terminal.
• "TV SOUND" for selecting the TV connected to
the [SCART] terminal.
• You can also select the connected device as
the source by repeatedly pressing [SOURCE]
on the main unit.
Start playback on the connected
device.
• Refer also to the instruction manual of the
connected device.
Adjust the volume and perform
other necessary settings.
• Refer to "Using this Product (Operation)" on
page 12.
Press [AUX] repeatedly to select
"AUDIO IN" in the display window.
Press [ENTER].
• "INPUT LEVEL1" or "INPUT LEVEL2" appears
in the display window.
Press [ENTER] repeatedly to select
"INPUT LEVEL1" or "INPUT
LEVEL2".
• Each time you press [ENTER], the display
toggles between "INPUT LEVEL1" and
"INPUT LEVEL2".
• The signal gain in "INPUT LEVEL1" is lower
than that in "INPUT LEVEL2".
• The display returns to "AUDIO IN" in
approximately 2 seconds.
24