Chapter 4
Configuring the Serial Interface
Example: Asynchronous Serial Configuration
This example shows how to configure a serial interface on asynchronous mode.
Router> enable
Router# configure terminal
Router(config)# interface serial 0/0/0
Router(config-if)# physical-layer async
Router(config-if)# ip address 10.0.0.2 255.0.0.0
Router(config-if)# async mode dedicated
Router(config-if)# end
Related Documents
Topic
PPP and Multilink PPP
Serial Interface Configuration
Frame Relay
Document Title
Configuring Media-Independent PPP and
Multilink PPP
Interface and Hardware Component
Configuration Guide, Cisco IOS Release
15M&T
Wide-Area Networking Configuration Guide:
Frame Relay, Cisco IOS Release 15M&T
Cisco 800M Series Integrated Services Routers Software Configuration Guide
Related Documents
49