Table of Contents
Advertisement
How to use
USING SOLAR POWER
•Direct the solar panel on the back of the hands-free car kit toward the sun.
(Please refer to the recommended installation position, as mentioned above.)
•For every 2 hours the cradle Solar Panel receives sufficient sunlight, (while
the headset is attached), the headset will receive an extra one hour of talk
time (up to 4.5 hours total). When using solar power to charge the HBM-810,
the talk time and standby time will be extended, without any need to plug in
the charger.
* WARNING : Do not attempt to charge the HBM-810 with any charger other
than the one provided in the box. Using another charger may damage the
HBM-810.
Pairng
- Before using the headset for the first time, you must pair it with a Bluetooth-
enabled handset.
- There are 2 Pairing Mode Methods with the HBM-810
Easy Pairing (First Time Pairing)
1. Move the Power switch to the ON position to turn on the HBM-810 (you will see
green beneath the power switch). When the Headset enters Pairing Mode, the
LED indicator will show a solid blue light (Speech: "Please pair phone now").
2. Using your handset, find the Bluetooth Menu and "search for" or "add" new
devices.
•Select "LG HBM-810" from the list of devices and pair it with your handset.
3. If asked for the Pass/PIN code please enter "0000" (4 Zeros).*
* Note : If your handset supports Secure Simple Pairing(SSP), you will not
need to enter Pass/PIN code.
•Once pairing has completed successfully, you will hear "Paired to phone
successfully".
4. Once paired, be sure to connect to the phone. You will hear "Connected to
phone".
•Some handsets might ask for permission to access the phone's contact
list. If you receive a message from your handset, please select "OK" or "Allow
access"
•The HBM-810 will automatically turn off if not paired within 3 minutes.
6
Manual Pairing
•With the Power off, press the CALL button and move the Power Switch to
the on side at the same time. Hold for 2 seconds.
•When the Headset enters Pairing Mode, the LED indicator will show a solid
blue light and you will hear, "Please pair phone now". Repeat Easy Pairing
steps 2 through 5.
Multipoint
- The LG HBM-810 is capable of having two handsets connected to the
headset at the same time. This will give you the freedom of having only one
Headset to operate both of your handsets.
Multipoint Connect
- Pair the headset with one of your Bluetooth-enabled handsets.
(per the easy pairing instructions on Manual Pairing).
- Turn off the headset. Now, follow the manual pairing process with your other
Bluetooth-enabled handset.
(This will be your Primary handset).
- Once this handset is paired and connected, go back and connect the first
paired handset to the headset. (This will be your Secondary handset).
Note: When the HBM-810 is connected to two handsets at the same time
(Multipoint), the headset calling functions will work with the Primary
handset (or handset which made the last outgoing call).
Controls
Headset power ON / power OFF
- Slide the Power Switch to the ON (green) / OFF (black) position.
Cradle power ON / OFF
- The cradle does not have power ON/OFF controls. When the headset is
inserted into the cradle with the power ON, the cradle automatically
powers ON. When the headset is removed, the cradle will power OFF.
Volume Control
- Briefly press the VOLUME UP/DOWN button.
Battery Status Alert
- To check the battery status, press and hold the VOLUME DOWN button for
3 seconds.
- There are 4 levels of battery status : "Battery full","Battery half","Battery low",
and "Battery very low"
How to use
7
Advertisement
Table of Contents
