Table of Contents
Advertisement
Update or reinstall
Update digital channels
You can always start an channel update yourself.
To start a channel update manually...
1 - Press , select All Settings and press OK.
2 - Select Channels > Antenna/Cable Installation.
3 - Enter your PIN code if necessary.
4 - Select Search for Channels.
5 - Select Start.
6 - Select Update digital channels.
7 - Press OK to update the digital channels. This
can take a few minutes.
8 - Press BACK to close the menu.
Quick reinstall
Select Quick reinstall to install all channels again with
default settings.
To start Quick reinstall...
1 - Press , select All Settings and press OK.
2 - Select Channels > Antenna/Cable Installation.
3 - Enter your PIN code if necessary.
4 - Select Search for Channels.
5 - Select Start.
6 - Select Quick reinstall.
7 - Press OK to update the digital channels. This
can take a few minutes.
8 - Press BACK to close the menu.
Advanced reinstall
You can reinstall all channels and leave all other TV
settings untouched.
If a PIN code is set, you will need to enter this code
before you can reinstall channels.
To reinstall channels...
1 - Press , select All Settings and press OK.
2 - Select Channels > Antenna/Cable Installation.
3 - Enter your PIN code if necessary.
4 - Select Search for Channels.
5 - Select Start and press OK.
6 - Select Advanced reinstall and press OK.
7 - Select the country where you are now and
press OK.
8 - Select the type of installation you want, Antenna
(DVB-T) or Cable (DVB-C) and press OK.
9 - Select the type of channels you want, Digital
and Analogue Channels or Only Digital
Channels and press OK.
10 - Press OK to update the digital channels. This
can take a few minutes.
11 - Press BACK to close the menu.
Automatic Channel Update
If you receive digital channels, you can set the TV to
automatically update these channels.
Once a day, at 6 AM, the TV updates the channels
and stores new channels. New channels are stored in
the Channels List and are marked with a .
Channels without a signal are removed. The TV must
be in standby to automatically update channels. You
can switch off Automatic Channel Update.
To switch off the automatic update...
1 - Press , select All Settings and press OK.
2 - Select Channels > Antenna/Cable Installation.
3 - Enter your PIN code if necessary.
4 - Select Automatic Channel Update.
5 - Select Off.
6 - Press (left) to go back one step or
press BACK to close the menu.
When new channels are found or if channels are
updated or removed, a message is shown at TV start
up. To avoid this message to appear after every
channel update, you can switch it off.
To switch off the message...
1 - Press , select All Settings and press OK.
2 - Select Channels > Antenna/Cable Installation.
3 - Enter your PIN code if necessary.
4 - Select Channel Update Message.
5 - Select Off.
6 - Press (left) to go back one step or
press BACK to close the menu.
In certain countries, the Automatic channel update is
done while watching TV or on any moment when the
TV is in standby.
DVB-T or DVB-C
DVB Settings
Network Frequency Mode
If you intend to use the fast Quick Scan method
in Frequency Scan to search for channels,
select Automatic. The TV will use 1 of the predefined
network frequencies (or HC - homing channel) as
used by most cable operator in your country.
If you received a specific network frequency value to
search for channels, select Manual.
Network Frequency
With the Network Frequency Mode set to Manual,
you can enter the network frequency value received
from your cable operator here. To enter the value, use
the number keys.
14
Advertisement
Table of Contents
