Honeywell 6824 User Manual page 84

Appendix B – Printer Control Codes
Set Horizontal Tabs
Description:
Decimal:
Hex:
ASCII:
Clear Horizontal Tabs
Description:
Decimal:
Hex:
ASCII:
Perform Vertical Tab
Description:
Decimal:
Hex:
ASCII:
74
Sets the horizontal tabs based on the current character width (pitch). Cancels any
previously set horizontal tabs.
Parameters are as follows:
•
n1 is the first tab. Range for tab stops is 1 to 160.
•
n2 is the second tab. Tabs are listed in ascending order.
•
... are subsequent tabs. Maximum number of tabs is 32.
•
nk is the last tab to set. Any value less than the previous tab value acts as a
terminating character.
•
NUL is the terminating character.
27 68 n1 n2 ... nk 0
1B 44 n1 n2 ... nk 00
ESC "D" n1 n2 ... nk NUL
Use this variant of the Set Horizontal Tabs control code to clear all horizontal tab stops.
27 68 0
1B 44 00
ESC "D" NUL
Prints the contents of the current print buffer, and then moves the print position to the
next vertical tab stop. If no channel is selected, then channel 0 is used. The carriage
position is changed to the start of the next print line.
•
If the vertical tab is performed beyond the last tab position set or beyond the last line
of a form, then a form feed is performed.
•
If no vertical tabs are defined, then the paper advances one line, using the currently
selected line spacing, without changing the carriage position.
11
08
VT
6824 Mobile Full Page Printer User Manual