Dealing With Problems (Summary) - Panasonic CF-37 Series Supplementary Instructions Manual

Dealing with Problems (Summary)

Replace the "Dealing with Problems (Summary)" for the following.
Starting Up
The power indicator or bat-
tery indicator is not lit
is displayed
[POST Startup Error(s)] is
displayed
Windows startup, or an op-
eration is extremely slow
The date and time are incor-
rect
When the previous item is
not the cause
Windows NT
NT does not start up
8
Check the cable connection for the AC adapter.
Check to see if a fully charged battery is properly installed.
Remove the battery pack and disconnect the AC adapter, then connect them again.
Input your password. If you have forgotten it, contact Panasonic Technical Support.
"Operating Instructions" page 17
Press F9 in the Setup Utility (
[Disable] in [Advanced] menu. This will restore the Setup Utility's settings to their default
values (except the password settings). Then, the Setup Utility must be run once again for
you to input the appropriate operating environment settings. (The processing speed de-
pends on the application software used, so this operation may not cause the processing
speed to increase.)
You can set the date and time through [Date/Time] in [Start] - [Settings] - [Control Panel].
If you continue to experience problems, the internal battery maintaining the clock may
need to be replaced. Contact Panasonic Technical Support.
When the computer is connected to a Local Area Network (LAN), confirm the date and
time of the server.
This computer will not correctly recognize the date and time starting from the year 2100
A.D.
Windows NT
When [APM 2.0 for NT] is not displayed in [Control Panel], this indicates that Phoenix
APM 2.0 for Windows NT
used under this condition, the date and time may be incorrectly displayed. Correct the
date and time, and then install Phoenix APM 2.0 for Windows NT
When the standby or hibernation function is used frequently, discrepancies may occur in
the display of the date and time even if APM 2.0 for Windows NT is installed. You can set
the date and time through [Date/Time] in [Start] - [Settings] - [Control Panel].
Press F9 in the Setup Utility (
[Disable] in [Advanced] menu. This will restore the Setup Utility's settings to their de-
fault values (except the password settings).
Try removing all peripheral devices.
If [Cancel] at the [Path not found] is clicked during the LAN card driver installation, the
next time the system is activated it will hang up without NT being activated.
In such cases, follow the steps listed below.
1 Power off, then power on again.
2 When [Press spacebar NOW to ...] is displayed, press the space key.
3 When [Hardware Profile/Configuration Recover Menu] is displayed, press L , then
press Enter .
4 At the [PCMCIA Card Not Configured], select [OK].
5 At the [Path not found], put the disk that was supplied with the LAN card into the disk
drive, then select [OK]. Follow the on-screen instructions.
"OPERATING INSTRUCTIONS
"OPERATING INSTRUCTIONS (page 19,20)"
"Setup Utility") and set [Plug & Play] to
®
is not installed. When the standby or hibernation function is
"Setup Utility") and set [Plug & Play] to
"
(page 19)
®
.