Pyle Pro PDWM96 Operating Instructions

WIRELESS CLIP-ON MINI. MICROPHONE
OPERATING INSTRUCTION
It is very happy that you have this professional Wireless Clip-on Mini. Microphone of
good quality which will bring you convenience when you are using it in the situation of
teaching,conference,monitoring etc.

HOW DO YOU OPERATE IT?

l.Open the bottom
polarity and close the bottom cover until it clicks
2.Insert the Mic. connector(9) into the socket(1) of transmitter.
3.0pen the battery cover
receiver with correct polarity and close the battery cover.
4.Plug the receiver into the input socket for microphone of amplifier, set both switch(2)
of transmitter and switch(8) of receiver to ON position, then the pilot
(7)
are on that indicates a good condition and it is ready for operation.

ATTENTIONS

1.If acoustic quality
batteries in transmitter
normal operation,you
receiver with a screwdriver
2.If your micropbone
avoid its deterioration and the damage of components.
3.If two wireless microphones
one red and another green lamp and can't use them with the lamp of the same color.
4.If the microphone is
loud,shrill sound will
case, please keep
volume of amplifier.

SPECIFICATIONS

I.Modulation ........ ............................... ..........
.
2.Frequency response .......................... .......... 80 to 12500 Hz
3.0utput impedance ........................................ 600 ohm
4.0perating voltage .................................... ... 9V DC for transmitter
5.Effective distance ........................................ 20 m
www.pyleaudio.com
�"3>PYLE® PDWM96
PR()
cover (4) of the transmitter,
(5) of the receiver,
and volume are abnormal
and receiver should
can carefully trim
become normal operation.
to
isn't used for a long
are used
too close to the
occur and that
microphone long distance
insert the
shut.
insert two batteries
or receiving
be . replaced,
the frequency by
period, the battery
at the same time,
speaker or the volume of the amplifier
may damage the amplifier
from the speaker
FM
3V DC for receiver
battery with the
(size AAA) into
lamps (3) and
distance is shortened,the
if thereafter still
adjusting the screw(6)in
should be taken
you should use them
or speaker.in
and turn down
correct
the
not in
out to
with
is too
that
the