Using the hidden commands
Performing commands using the receiver
This receiver allows you to perform various commands using buttons on the front panel.
User initialize (Memory Clear)
Sound Field Clear
Performing commands using the supplied remote control
This receiver allows you to perform various commands using the supplied remote control.
Changing the remote control code
While holding down MAIN, press MAIN .
MAIN will start flashing.
Press CUSTOM PRESET 1 or 2 to select AV1 or AV2 as needed.
MAIN will stop flashing and light up in red.
MAIN will start flashing again.
again to set the command mode.
Hold down for 5 seconds in standby mode.
Hold down MULTI.ST. and press in standby mode.
Hold down PING and AMP MENU and press ENTER while the
receiver is turned on.
Hold down 2CH/DIRECT and press in standby mode.