Porter-Cable 747 Instruction Manual page 12

ACCIDENTAL
SHOCK THE SAW MUST BE
HELD AS SHOWN IN FIG. 8A OR
8B, AND MUST HAVE THE
RUBBER FRONT HOUSING
COVER PROPERLY INSTALLED
AND NOT DAMAGED.
DO NOT USE THE
TOOL UNLESS THE ROTATING
HANDLE IS
POSITION. IF THE HANDLE
WILL NOT LOCK THE TOOL
MUST BE RETURNED FOR
REPAIR.
TO START AND STOP SAW
1. Make sure power circuit voltage is the same as shown on the
specification plate on the saw. Connect saw to power circuit.
2. Hold saw firmly. Squeeze trigger switch (A) Fig. 9, to start motor.
Release trigger to stop motor.
TO PREVENT
ELECTRICAL
LOCKED IN
Fig. 8A
Fig. 8B
A
Fig. 9
12
A
Fig. 8C