INSTALLATION Desk-top Installation 1. Determine the mounting location and drill four mounting holes. 2. Attach the bracket to the holes with the tapping screws (M4x10). 3. Let the two levers aim at the fixing holes on the bottom of the base to fix the display unit.
Page 3
INSTALLATION Ceiling-on Installation Bracket Mounting Bolts (M3x6) 1. Determine the mounting location and drill four mounting holes. 2. Attach the bracket to the holes with the tapping screws (M4x10). 3. Let the two levers aim at the fixing holes to fix the display unit. 4.
REPLACING THE CAR DOME LAMP Follow the directions show below for a new lamp changing. 1. Position light switch to “ 2. Push back the lamp cover and open it. (Refer to the following figure) 3. Remove and discard the old lamp. 4.
Page 6
CONTROL & FUNCTION KEYS 7 INCH TFT COLOR MONITOR...
Page 7
MONITOR (=POWER) Press button (1) to turn on the unit. Press it again to turn it off. POWER INDICATOR LIGHT When the system is on, the indicator light (2) will be illuminated. CAR DOME LAMP The car dome lamp (3) will be on in some needed situations. LIGHT SWITCH The are three seetings for the car dome lamp operation: (ON), refer to light switch (4).
Page 8
13. PUSH (Monitor Release Button) Opening the Monitor Press the PUSH button (13) to eject the screen display from the base at a little angle. Then you can easily turn the display upward or downward for good viewing. The monitor also can be adjusted through 30 degree both left and right from the central viewing position Closing the Monitor Return the monitor to the central viewing position.