Battery Charging; Battery Installation - Triumph Bonneville Handbook

Hide thumbs Also See for Bonneville:
Table of Contents

Advertisement

Maintenance and Adjustment

Battery Charging

For help in selecting a battery charger,
checking the battery Voltage or battery
charging, contact your local authorised
Triumph dealer.
Warning
The battery gives off explosive gases; keep
sparks, flames and cigarettes away. Provide
adequate ventilation when charging or
using the battery in an enclosed space.
The battery contains sulphuric acid (battery
acid). Contact with skin or eyes may cause
severe burns. Wear protective clothing and
a face shield.
If battery acid gets on your skin, flush with
water immediately.
If battery acid gets in your eyes, flush with
water for at least 15 minutes and SEEK
MEDICAL ATTENTION IMMEDIATELY.
If battery acid is swallowed, drink large
quantities of water and SEEK MEDICAL
ATTENTION IMMEDIATELY.
KEEP BATTERY ACID OUT OF THE
REACH OF CHILDREN.
Caution
Do not use an automotive quick charger as
it may overcharge and damage the battery.
Should the battery Voltage fall below
12.7 Volts, the battery should be charged
using a Triumph approved battery charger.
Always
remove
the
battery
motorcycle
and
follow
the
supplied with the battery charger.
96
For extended periods of storage (beyond two
weeks) the battery should be removed from
the motorcycle and kept charged using a
Triumph approved maintenance charger.
Similarly, should the battery charge fall to a
level where it will not start the motorcycle,
remove the battery from the motorcycle
before charging.

Battery Installation

Ensure that the battery terminals do not
touch any part of the motorcycle as this
may cause a short circuit or spark which
would ignite battery gases causing a risk of
personal injury and damage to the
motorcycle.
Ensure the Engine Control Module
(ECM) and its cover are correctly
located behind the battery.
Place the battery in the battery case.
Reconnect the battery leads, positive
(red) lead first.
Apply a light coat of grease to the
terminals to prevent corrosion.
Cover the positive terminal with the
protective cap.
Refit the battery strap.
Refit the seat as described in the
General Information section.
from
the
instructions
Warning

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents