Summary of Contents for PYLE Audio 10" SUPER SLIM ACTIVE SUBWOOFER PLBASS10
- Page 1 Mounting the subwoofer 1. Find a suitable location in the vehicle in which A typical location is shown below: 2. Make sure there is sufficient air circulation around the intended mounting location. 3. Mark. the location for mounting hole screws by positioning the cabinet where you wish to inst all it.
- Page 2 PLBASS10 1000 Watts Max 10” Super Slim Active Subwoofer 10” Slim woofer RCA low level input High level input Green & red LED power status indicator Remote level control Phase shift switch: 0 or 180° Adjustable input sensitivity: 0.2V-3V 0 to +12dB variable Bass Boost (@45Hz) Low pass filter (50-150 Hz) Soft delay remote turn-on Thermal, short and overload protection circuits...
- Page 3 Low Level Input Wiring Low-level (RCA) input wiring is preferred for best audio performance. Most trunk or hatchback installations will require a 15-20 foot RCA cable, while pickup trucks and under-seat installations will require a 6-12 foot RCA cable. Always use a high-quality cable. NOTE: Do not connect BOTH the high level and low level inputs from your receiver your amplifier at the same timel...
- Page 4 Front panel controls and features POWER ON LED INDICATOR ® PHASE SHIFT Use this switch to help compensate for time alignment problems in the system. Such problems usually result from having the subwoofer at a different distance from the listener than the other speakers in the system. @ INPUT GAIN CONTROL After you have installed your system, turn this control to minimum.