Listening To The Radio - Sony CMT-M80V Operating Instructions Manual

Presetting radio stations (continued)
Other Operations
To
Tune in a station
with a weak
signal
Change the preset
station
Change the preset
number
Note
If "Complete!" does not appear when you press
ENTER on the remote in step 6, press DISPLAY on
the remote, then start over from step 1.
To change the AM tuning interval
(Except for Middle Eastern and
Philippine models)
The AM tuning interval is factory-preset to 9 kHz.
To change the AM tuning interval, tune in any AM
station first, then turn off the system. While holding
FM MODE, press ?/1. When you change the
interval, all the AM preset stations are erased. To
reset the interval, tune in any AM station first, then
turn off the system. While holding FM MODE, press
?/1.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for about a day even
if you disconnect the mains lead or if a power
failure occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
GB
18
Do this
Follow the procedure described
in "Setting presets through
manual tuning".
Start over from step 1.
Start over from step 1.

Listening to the radio

You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner's memory first
(see "Presetting radio stations" on page 17).
1
Press TUNER FM or TUNER AM (or
TUNER BAND on the remote) to select
FM or AM.
2
Press TUNING MODE repeatedly until
"PRESET" appears in the display.
3
Press TUNING + or – (or, m or M on
the remote) repeatedly to select the
desired preset station.
To select the desired preset number
using the numeric buttons on the
remote
Press numeric buttons instead of performing
step 3.
To enter preset number 10 or higher, press >10
and the corresponding numeric buttons. To
enter 0, press 10/0.
Example:
To enter preset number 20, press >10, then 2 and
10/0.