Table of Contents
Advertisement
5.3.2 ONE CALL: DIRECT ACTIONS
5.3.2.1 S
PEECH VOLUME ADJUSTMENT
L2
Connected call screen:
Press
John
A bar graph is displayed during tuning and the audio level is modified accordingly.
00:00:10
Special tones indicate that the minimum or maximum level has been reached.
Names
Menu
8 levels are foreseen for audio adjustment.
Access to speech volume control
Ring volume control screen:
Continuous presses on
Speech Volume
(In a circular way). The conversation volume is played as tuning feedback
The function is exited when no actions on keys after 2 seconds or by a press on any key.
Vol-
Vol+
Increase the volume control value.
The volume is immediately modified and no validation is needed to confirm the modification.
An other way to tune the volume is to use the left softkey (volume decrease) or right softkey (volume increase). An
"AUDIO_VOLUME_KEY_ERROR_TONE is played when overstepping the bounds).
Ring volume control screen:
Speech Volume
Vol-
Vol+
"Timer"
Leave the process
L2
Connected call screen:
John
00:00:10
Names
Menu
5.3.2.2 S
DTMF
ENDING
If the connected call is active, entering
digits are displayed on the screen as for a dialling screen. The DTMF tone feedback corresponding to the key
pressed is played at the same time, as long as the key is pressed.
5.3.2.3 M
AKING A NEW CALL
The same means used to make a new call from the idle screen can be used to make a new call while in a
conversation. The current connected call is put on hold automatically and the new call becomes active when
connected. After the new call connection, the display is a "two connected calls" one. See details below for this
display. The feature with the international country codes access is also available.
5.3.2.4 E
ND THE CALL
See next section
.
CONFIDENTIAL
adjust the audio volume.
key allow an continuous audio level increase or decrease operation
TONES
0
..
9
,
*
,
#
sends DTMF tones to the remote party. At the same time,
Mitsubishi Electric
Page 51/102
Advertisement
Table of Contents
