Download  Print this page

Advertisement

P
9-16
AGE
b. Let the device run for at least 10 minutes on 0.5 LPM continuous flow. Record the results of
the O2 purity from the O2 Analyzer and the internal O2 sensor on the test data sheet.
26. Verify the functionality of the control panel buttons. Then turn the device off and listen for three
audible tones signifying the device turning off. Record results on the test data sheets.
27. Ensure loss of power alarm is installed in SimplyFlo's dataport
28. Power the device ON. Allow the device to operate for 1 minute.
29. Unplug the power supply from the running SimplyFlo.
30. Verify that the loss of power alarm is clearly audible. Record the results on the test data sheet.
31. Tilt SimplyFlo 90 degrees left or right. Verify that the alarm silences. Record the results on the test
data sheet.
32. Re-connect the device to the power supply. It should power ON.
33. Allow the device to run at least 10 seconds.
34. Power the device OFF by pressing the POWER button twice.
35. Unplug the power supply. Verify the alarm does not sound. Record the results on the test data
sheet.
36. If the SimplyFlo fails testing, turn the unit completely off and retest the unit.
If performing the Final Test and Balance Test due to the replacement of either the Main PCA, Sieve
Bed, Compressor, or Process Valve, perform the Balance Procedure.
Balancing Procedure
Perform only if a Main PCA, Sieve Bed, Compressor, or Process Valve has been replaced.
1. Power the device ON and set the device to a setting of 0.5 in continuous mode.
2. Before using the "Learn Pressure Bal" command verify the O2 factors are 1.00. If they are not
then reset the O2 factors by clicking the reset button.
a. On the Usage Hours Tab click the "Learn Pressure Bal" check box. The device screen
changes to 2 LPM continuous.
b. Let the device run for 15 minutes then record the results of the O2 purity from the O2 Analyzer
and the internal O2 sensor on the test data sheet.
NOTE
1097626, V
. 03
ER

Advertisement

Table of Contents

   Also See for Philips SimplyFlo

This manual is also suitable for:

Simplygo

Comments to this Manuals

Symbols: 0
Latest comments: