Ps audio multiwave ii ac waveforms: supplementary guide (1 page)
Summary of Contents for PS Audio P1200
Page 1
MultiWave Installation Instructions P300, P600, P1200 You MUST have MWII installed prior to adding the Plus software Table of Contents • One display microchip • One MWII card microchip 1...What’s in the Box • One chip puller 2...Warning • One plastic dentist mirror 2...Safety Instructions...
If you have any questions at any time, please contact your dealer, distributor If the Power Plant is powered on with the or PS Audio by e-mail, fax or telephone at oscillator card inserted backwards, the the numbers listed at the end of the instruc- Power Plant will require service from an tions.
Page 3
Using the same technique you used for dot must face to removing the front panel display chip, locate the RIGHT on the same looking chip on the separate MWII the P600/P1200 board. Note the small half moon and and the LEFT white dot and on the P300.
Replace the screws in the bottom cover. Any turntable or equipment with AC synchronous motors, such as some cooling Replace the top cover - P600/P1200 fans should not be used with MultiWave Line the top cover up against the front bezel patterns.
Warranty inside the U.S. and generation of frequencies as MultiWave2 waveform, however it generates more tube- friendly frequencies. PS Audio’s warranty is 3 years parts and labor, from the date of original purchase. This means [P-1] MultiWave1 that we warranty the product itself regardless MultiWave1 is a single 60Hz sine wave with of ownership, new or used.
Need help?
Do you have a question about the P1200 and is the answer not in the manual?
Questions and answers