Chapter 5 Detailed Settings
5.8
Setting Commands
There are two types of commands handled by this device. These are GP-GL and HP-GL. Match this with the
setting value of the software being used or set this to AUTO. However, depending on the application being
used, the device may not operate properly with the AUTO setting.
These items are available only when using the GP-GL or HP-GL commands.
Once you are done with the setting, touch the
Selecting the Command
Select the command to use.
1.
From the "MENU" screen, open the "INTERFACE 1/3" screen.
2.
Select the command to use.
Setting the HP-GL Origin Point
This item is available only when using the HP-GL command.
1.
From the "MENU" screen, open the
"INTERFACE 1/3" screen and proceed to
the "INTERFACE 2/3" screen.
2.
Under "HP-GL ORIGIN POINT", select
"LOWER LEFT" or "CENTER".
Setting the HP-GL Model Emulated
This item is available only when using the HP-GL command.
1.
From the "MENU" screen, open the
"INTERFACE 1/3" screen and proceed to
the "INTERFACE 2/3" screen.
2.
Under "HP-GL MODEL EMULATED", select
"7550" or "7586".
5-24
(Exit) to return to the "HOME" screen.