Assigning Parameters For The L2 Interface Of The S5-95U; Db1 With The Default Parameters - Siemens SIMATIC S5 Manual

System Description
1.4

Assigning Parameters for the L2 Interface of the S5-95U

You assign the parameters for the L2 interface in DB1, in the parameter block with block ID "SL2:".
Irrespective of the type of data transmission you select, you must assign certain parameters (basic
parameters) in DB1. The basic parameters affect only the procedures for accessing the network
(see section 1.3) and not the communication mechanisms. DB1 has default settings for the basic
parameters that you can use or change according to the task to be performed.
The default DB1 is illustrated in Figure 1-6.
0: KS ='DB1 0BA: AI 0 ; 0BI:
12: KS =' ; 0BC: CAP N
24: KS ='N
36: KS ='DB2
48: KS =' CBR FY100
60: KS ='01
72: KS ='T 128 PBUS N ; TFB: OB13';
84: KS =' 100
96: KS ='2
108: KS =' SET 3
120: KS ='00
132: KS =' TIS 3 01.10. 12:00:00 ';
144: KS =' STP Y SAV Y
156: KS =' #SL2: TLN 0
168: KS =' BDR 500
180: KS ='5120
192: KS ='SDT 1 12
204: KS =' DB6
216: KS =' KBS MB62
228: KS ='# END ';
The basic parameters and their ranges are listed and explained in the following Table.
1-8
';
CBP ';
;#SL1: SLN 1 SF ';
DW0 EF DB3 DW0 ';
CBS FY1';
PGN 1 ;# SDP: N';
; #CLP: STW MW10';
CLK DB5 DW0 ';
01.10.91 12:00:';
OHS 000000:00:00 ';
CF 00 ';
STA AKT';
HSA 10 TRT ';
SET 0 ST 400 ';
SDT 2 360 SF';
DW0 EF DB7 DW0 ';
KBE MB63 ; ';
Figure 1-6. DB1 with the Default Parameters
Parameters for S5-95U
functions described in the
S5-90U/S5-95U system
manual
Basic parameters
Parameters for type of data transmission
( Chapters. 4, 6, 7 and 8)
S5-95U, SINEC L2
EWA 4NEB 812 6112-02