Siemens SIMATIC S5 Manual page 183

Programmer Functions Over the SINEC L2 Network
Press <F4> (ACTIVATE) in the "FUNCTION SELECTION/DEFAULTS"
screen.
The edited path appears on the monitor.
SINEC L2
F1
SYSID
Activate the first path level by pressing <F3> (SUBPATH).
The activated subpath is then marked with an "* ", and "DIRECT PG LINK ESTABLISHED" appears
in the message bar.
Press <F1> (SYSID) to match the local LAN parameters of the CP-L2 communications
processor in the programmer to the L2 LAN parameters (basic L2 parameters) of the system
( section 9.5).
9-8
PG/CP-L2
CP-L2
ENDP
F2 F3 F4
SUBPATH
Figure 9-6. Screen for Activating a Path (1)
PATH NAME : ST2/95U
ADDRESS : 2
F5 F6 F7
TOTAL
S5-95U, SINEC L2
F8
EXIT
EWA 4NEB 812 6112-02