Instructions for the user Important Safety Information Description of the appliance Technical Features Using the appliance Before using the cooker for the first time Using the oven Hints & Tips Cooking with the grill Using the Hob Maintenance and Cleaning Before you call for Service The symbols below will guide you when reading the CONTENTS...
IMPORTANT SAFETY INFORMATION You MUST read these warnings carefully before installing or using the appliance. Installation • This cooker must be installed by qualified personnel, according to the manufacturer’s instructions and to the relevant British Standards. • This cooker is heavy. Take care when moving it.
Door handle Oven door glass semi-rapid Adjustable feet 1. Front left burner (semi-rapid) 2. Back left burner (semi-rapid) 3. Back right burner (auxiliary) 4. Front right burner (rapid) Model : EFG 502 FRONT BACK LEFT LEFT BURNER BURNER BURNER CONTROL CONTROL...
Free standing Pan support Front right burner Back right burner Front left burner Back left burner Oven power Oven Grill power Oven shelf Accessories Grill pan Heat deflection shield Height to the hob Dimensions Width Depth This appliance complies with the following EEC Directives : 90/396 (Gas Appliance Directive) 93/68 (General Directives) and subsequent...
Before using the cooker for the first time Remove all packaging both inside and outside of the cooker, before using it. Before using for the first time, the oven should be heated without food. During this time, an unpleasant odour may be emitted. This is quite normal.
Ignition Attention: when turning on the oven and grill burner the oven door has to be opened. • Open the oven door and lift the small flap on the bottom of the oven cavity. • Hold a lit match or taper to the oven burner. •...
Cooking with the grill Whenever the grill is in use the heat deflection shield must be fitted to prevent the overheating of the control knobs and facia panel. • First of all fit the heat deflection shield "A" • Hold a lighted match or taper to the grill burner.
Using the Hob The Hob Burners The symbol on the knob corresponds to a symbol on the control panel (See description of appliance). Maximum level Minimum level Use the maximum position for boiling and the minimum for simmering. Always choose positions between the minimum and maximum, never between maximum and off.
Selecting the Correct burner Above every control knob there is a symbol for the corresponding burner. For good cooking results, always choose pans, which correctly fit to the diameter of the burner used (see figs). Choose thick, flat bottom pans. We recommend the flame is lowered as soon as the liquid starts boiling.
MAINTENANCE AND CLEANING The oven should be kept clean at all times. A build-up of fats or other foodstuffs could result especially in the grill pan. Before cleaning, ensure all control knobs are in the OFF position, and the appliance has cooled completely. Cleaning materials Before using any cleaning materials on your oven, check that they are suitable and that their...
Oven Cavity The enameled oven cavity is best cleaned whilst the oven is still warm. Wipe the oven with a soft cloth soaked in warm soapy water after each use. From time to time it will be necessary to do a more thorough cleaning, using a proprietary oven cleaner.
BEFORE YOU CALL FOR SERVICE If the appliance is not working correctly, please carry out the following checks, before contacting your local Comet Service Centre. Symptoms 1. No burner ignition 2. The gas ring burns unevenly 3. The oven or grill burner will not ignite. 4.
INSTRUCTIONS FOR THE INSTALLER SAFETY ADVICE Important This appliance is supplied for use on NATURAL GAS ONLY and cannot be used for any other gas without modification. Conversion for use on other gases must only be undertaken by a qualified person. For information for use on other gases contact your local Comet Service Centre.
Positioning Remove all the packaging and install the cooker in a dry well, ventilated room away from curtains, paper, alcohol, petrol etc. (See figure). This appliance is approved to class “1” regarding overheating of surrounding surfaces. It is mandatory to keep 20 mm distance from the adjacent furniture.
Fitting the adjustable feet Unpack the support brackets with the feet attached. Place a piece of cloth/cardboard onto your floor to prtect both your floor and the cooker. Lay the cooker on its back, fit the support brackets (see fig) using the bolts, washers and nuts supplied and ensure that the nuts are tight.
Page 18
Hob burners • Remove the pan support; • Remove the caps and the burner crowns; • Using a No 7 socket spanner unscrew the injectors and replace them with those required for the type of gas in use (see table no.
Page 19
Grill burner To replace the grill injector, follow this procedure: • Remove the grill burner after removing the fixing screw. • Replace the injector by means of a No 10 socket spanner; • Refit all parts and test. Flame adjustment Oven burner The burner is correctly adjusted when the flame is stable, silent and goes out without any noise.
Need help?
Do you have a question about the EFG 502 and is the answer not in the manual?
Questions and answers