Mitsubishi Electric CBV2-A01D1 Instruction Manual page 27

6.3.2 Housing the sub unit
(1) Housing the sub unit
(2) Attaching the cover
Hold the sub unit on the top and bottom to push the
unit into the case approx. a half of the unit.
Note)
- Be careful not to touch the PCB and parts inside
the sub unit.
- The sub unit is so constructed that it can not be
housed in the case upside down.
Fully insert the sub unit into the case until you
hear a click while pressing the handles located on
both sides of the front of the sub unit.
Note) Please note that inserting the sub-unit
incompletely may only establish a poor
contact of the terminals located on the back
of the unit, which may cause operational
failure or heating.
Fit the cover straight to the case. Hold the cover
frame to fully push the cover until it is clicked
and locked.
Note) After setting the cover, check if the buttons
can be smoothly pressed from over the
cover.
27 PCKN-OIL738