Error Code S - Marquardt Series 4313 Original Operating Manual

Error Codes
7 Error Codes
The Control Panel Comfort displays error codes for the entire pedelec system. Error codes rep-
resent errors recognized by the system. The following table provides the meanings of these er-
ror codes. Please note the recommended reactions to error codes.
Error code Description
10 The Battery voltage is too low.
11 The Battery voltage is too high.
The battery is almost / completely dis-
12
charged.
20 Electrical measurements are incorrect.
21 Thermal sensor defective.
The Internal voltage is outside of the
24
working range.
25 Error in motor current measurement.
26 A software reset was completed.
40/41 Overcurrent in the motor.
42 Fault in motor rotation.
43 Short circuit in motor.
18
WARNING!
Pay attention to error codes!
Error codes can indicate serious faults in the pedelec system. These errors pre-
vent safe operation of the pedelec. They may result in personal injury or dam-
age to the pedelec.
Stop riding the pedelec. Determine the meaning of the error code and observe
the recommendations to correct the error.
If you are not certain what the error code means, stop riding and park your bicy-
cle. Contact the manufacturer, retailer, or your workshop for information on what
to do next.
Solution approach
Charge the battery pack using the battery charger.
Switch off the system completely and then back on
using the Control Panel button T4. If the problem
persists, contact your e-bike dealer.
Charge the battery pack using the battery charger.
Switch off the system completely and then back on
using the Control Panel button T4. If the problem
persists, contact your e-bike dealer.
Charge the battery pack using the battery charger.
Switch off the system completely and then back on
using the Control Panel button T4. If the problem
persists, contact your e-bike dealer.
Reduce the load on the motor by pedaling less or
by reducing the assist level.
Switch off the system completely and then back on
using the Control Panel button T4. If the problem
persists, contact your e-bike dealer.
Control Panel Comfort for Pedelecs