Advertisement
Choose a Location
Choose a location that is not near
a heat source or on somthing that
moves (like a door).
Install Adapter
1. Separate the adapter from the wall plate.
2. Open the battery cover in the wireless adapter
and install the CR2032 battery.
3. Remove the existing doorbell chime from the
wall.
4. Screw the wall plate to the wall using the
included screws and anchors (if necessary).
Drill 1/4 inch holes for the anchors.
Wiring
1. Make sure at least 1/3-inch of each wire
is exposed for easy insertion into the wire
terminals.
2. Insert the wires into the appropriate terminals.
Refer to the wiring diagrams below.
3. Connect the wires to the adapter terminals.
You can connect one or two doorbell pushes
and transformers.
A1/A2
B1/B2 Connect to a second push button (if used)
AC1
AC2
4. When the wiring is complete, turn the power back on.
Wiring 1 (A only) or 2 (A and B) Pushes
33-00195EFS_A.HALF-SHEET.indd 2
Connect to one push button
Connect to one line voltage transformer (if used)
Not used
B
A
Wiring 1 (A o/nly) or 2 (A and B)
Pushes with 1 Transformer
2
1/3 in.
B
A
4/20/2016 4:40:42 PM
Advertisement
