Epson BrightLink 485Wi Manual page 4

In most cases, this USB cable has been installed by the AV Team and will be green
in color. The 'A' end of the cable will plug into any available USB port on your PC.
The other end of the cable, the 'B' end, will plug into a wall plate located near the
AVP.
From this point the signal travels over in-wall cabling to the projector. Again, only
a GCS Technician will be able to access the connection points either in the wall or
at the projector.
If you have issues with your projector not displaying the image from your PC, or
your interactive pen stops working, check these connections behind your PC and
at the wall prior to opening a ticket. If these connections are secured properly
and you still have issues, please open a ticket with the AV Team with Technology
Services.
Listed below are the steps necessary to operate your Epson 485wi in a classroom
environment.
Step 1 – Power on the projector. You can reach up and push the power button on
the projector or you can use the power button located on the remote. In either
case, you should hear the projector beep and the amber light should turn green
and start blinking while the power up cycle runs its course.
-3-