Monitor Function (Current Value Change) - Mitsubishi Electric MELSEC iQ-R Series User Manual

Cc-link ie field network remote head module
Hide thumbs Also See for MELSEC iQ-R Series:
Table of Contents

Advertisement

1.7

Monitor Function (Current Value Change)

This function changes the value of the remote head module device or the buffer memory of the intelligent function module
mounted on the remote head module.
When the CPU module on the master station is in the STOP state, the value of device (Y) on the remote head module side
can be set as on.
The following table lists the output depending on the current value change of device (Y) and operating status of each module.
For the method of current value change, refer to the following.
 GX Works3 Operating Manual
Remote head module
Status of the CPU
status
module on the master
station
RUN
RUN
RUN
STOP
RUN
STOP
RUN
STOP
RUN (when disconnected)
STOP (when disconnected)
Current value
Output status
change of
device (Y)
ON
ON
OFF
OFF
(When the master station is performing transmission so that the output
status of device (Y) of the remote head module is turned on, the output
status of device (Y) will not become off even if current value change is
performed from the remote head module.)
ON
ON
OFF
OFF
OFF
(If the CPU module of the master station goes into the STOP state, the
remote head module will also go into the STOP state. At this time, if the
master station is performing transmission so that the output status of
device (Y) of the remote head module is turned on, the output status of
device (Y) will not become off even if current value change is performed
from the remote head module.
When the link refresh source of RY of the master station is set to Y, the
master station will not send ON because it will be cleared even if "Hold" is
set for the output status setting for CPU STOP.)
ON
ON
OFF
OFF
ON
ON
OFF
OFF
1.7 Monitor Function (Current Value Change)
1
1 FUNCTIONS
41

Advertisement

Table of Contents
loading

Table of Contents