Important - Philips SE360 User Manual

1 Important

Safety instructions
Power requirements
This product requires an electrical supply
of 100-240 volts AC. In case of power
failure, the communication can be lost.
as TNV-3 (Telecommunication Network
60950.
Warning
hazardous. The only way to power down the
charger is to unplug the power supply from
the electrical outlet. Ensure that the electrical
outlet is always easily accessible.
To avoid damage or malfunction
Caution
Use only the supplied batteries and adaptor
Do not allow the charging contacts or the
battery to come into contact with metal
objects.
Do not open the handset, base station or
voltages.
Do not allow the charger to come into contact
with liquids.
incorrection type.
Dispose of used batteries according to the
instructions.
Always use the cables provided with the
product.
For pluggable equipment, the socket-outlet
shall be installed near the equipment and shall
be easily accessible.
Handsfree activation could suddenly increase the
volume in the earpiece to a very high level: make
sure the handset is not too close to your ear.
This equipment is not designed to make
emergency calls when the power fails. An
alternative has to be made available to allow
emergency calls.
caused by heating equipment or direct sunlight.
Do not drop your phone or allow objects to
fall on your phone.
Do not use any cleaning agents containing
alcohol, ammonia, benzene, or abrasives as
these may harm the set.
Do not use the product in places where there
Do not let small metal objects come into
contact with the product. This can deteriorate
audio quality and damage the product.
Active mobile phones in the vicinity may cause
interference.
Metallic objects may be retained if placed near
or on the handset receiver.
About operating and storage temperatures
Operate in a place where temperature is
always between 0°C to +35°C (32°F to
95°F).
Store in a place where temperature is
always between -20°C and 70°C (-4° F
to 158° F).
Battery life may be shortened in low
temperature conditions.
Equipment approval Information
Your telephone equipment is approved for
connection to the public switched telephone
network and is in compliance with parts
15 and 68, FCC Rules and Regulations and
the Technical Requirements for Telephone
Terminal Equipment published by ACTA.
On the bottom of this equipment is a label
indicating, among other information, the US
number and Ringer Equivalence Number
(REN) for the equipment.You must, upon
request, provide this information to your
telephone company.
The REN is useful in determining the number
of devices you may connect to your telephone
line and still have all of these devices ring
when your telephone number is called. In
most (but not all) areas, the sum of the RENs
of all devices connected to one line should
of devices you may connect to your line as
determined by the REN, you should contact
your local telephone company.
EN
5