Download  Print this page

Checking Your Monitor Revision - Philips IntelliVue MP5 Instructions For Use Manual

Patient monitor.
Hide thumbs


Table of Contents
2 Basic Operation
Adjusting the Screen Brightness
Select the
Select the appropriate setting for the screen brightness. 10 is the brightest, 1 is the least
bright. Optimum is suitable for most monitoring locations and optimizes power usage
for battery powered monitors.
Your monitor may be configured with a lower brightness for Standby mode and also for transport to
conserve battery power. These settings can only be changed in the monitor's Configuration Mode.
Adjusting Touch Tone Volume
The touch tone volume is the tone you hear when you select any field on the monitor screen. To adjust
the touch tone volume,
In the Main Setup menu, select User Interface
Select Touch ToneVolume, then select the appropriate setting for the touch tone volume: 10 is
the loudest and 1 is the quietest. Selecting zero switches the touch tone volume off.
Setting the Date and Time
If your monitor is connected to an Information Center, the date and time are automatically taken from
this. Once it is set, the internal clock retains the setting even when you switch off the monitor.
Select the Date, Time screen element from the monitor's info line to enter the Date, Time
Select, in turn, the Year, Month, Day, Hour (in 24 hour format, only) and Minute as
necessary. Select the correct values from the pop-up list.
Select Store Date, Time to change the date and time.

Checking Your Monitor Revision

Select Main Setup -> Revision to open the Monitor Revision menu.
From the Monitor Revision menu, select the monitor component for which you need
revision information.
Getting Started
Once you understand the basic operation principles and have completed the Training Program, you
can get ready for monitoring.
Inspecting the Monitor
If the monitor is mechanically damaged, or if it is not working properly, do not use it for any
monitoring procedure on a patient. Contact your service personnel.
Before you start to make measurements, carry out the following checks on the monitor.
– Check for any mechanical damage.
Checking Your Monitor Revision


Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: