Download  Print this page

Understanding Screens - Philips IntelliVue MP5 Instructions For Use Manual

Patient monitor.
Hide thumbs

Advertisement

Table of Contents
2 Basic Operation
Select anything on the screen or press any key.
If you connect an MP5 that is powered on (and not in Standby) to a host monitor in Standby mode,
the host will leave Standby mode. When connected to a host monitor, with both the host and the MP5
in Standby mode, leaving Standby on the MP5 will also make the host leave Standby.

Understanding Screens

Your monitor comes with a set of preconfigured Screens, optimized for common monitoring scenarios
such as OR adult, or ICU neonatal. A Screen defines the overall selection, size and position of waves,
numerics and SmartKeys on the monitor screen when you switch on. You can easily switch between
different Screens during monitoring. Screens do NOT affect alarm settings, patient category and so
forth.
Switching to a Different Screen
1
To switch to a different Screen, select the monitor info line and then Change
Screen in the Setup Menu, or select the Change Screen SmartKey.
2
Choose the new Screen from the pop-up list.
Changing a Screen's Content
If you do not want to change the entire Screen content, but only some parts of it, you can substitute
individual waves, numerics, high-res waves, or trends. Be aware that these changes cannot be stored
permanently in Monitoring Mode.
To change the selection of elements on a Screen,
Select the element you want to change.
1
From the menu that appears, select
2
Change HiResTrend, and then select the wave or numeric you want, or select the high-
resolution trend wave you want from the list of available waves.
If you do not see Change Numeric in the menu, this Screen may be configured to always
display the numeric beside its wave. Changing the wave will automatically change the numeric.
The changed Screen is shown with an asterisk in the monitor info line.
20
, Change Numeric, or
Change Wave
Understanding Screens

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: