Download  Print this page

Sample Report Printouts - Philips IntelliVue MP5 Instructions For Use Manual

Patient monitor.
Hide thumbs

Advertisement

Table of Contents
23 Printing Patient Reports
Printer Status Message
Print device
<Printer name>
unavailable - job
suspended
Print Database
full -> job
suspended
Job on <Printer
name> failed
Print job on
device <Printer
name> done

Sample Report Printouts

Each report header contains the patient's bed label, last name and first name, middle name (if there is
enough space) the patient ID, the date and time, and the name of the report. The report footer
contains the hospital label and page number, and the last page contains a note to mark the report end.
The monitor may be configured to leave a space on the top left or right of the report printout to enable
you to stick a patient address label on it. This setting is called the Addressograph and it can only be
changed in the monitor's Configuration Mode.
252
Possible causes and suggested action
The chosen device is unavailable. Check that the printer is properly
connected and that paper is available. The requested report will start
printing when the printer becomes available.
The requested report does not fit into the print database. You can select
another printer to print the report (see "Unavailable Printer: Re-routing
Reports" on page 249). Alternatively you can delete another report from
the Reports Job List (using the Stop report key) to create space for your
report.
A report cannot be started on the requested printer.
One of three reasons will also be shown in the status message:
• data requisition error - an internal error has caused data required for
the report to be unavailable, try starting the report again.
• printer unavailable - make sure the printer is plugged in, switched
on, and has paper loaded.
• data unavailable - the connected X2 or MP5 has been removed
before the data for the report was transferred.
The report has been printed.
Sample Report Printouts

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: