Download  Print this page

Advertisement

Table of Contents
Setting up all CO
Measurements
2
Correction
Humidity
Gas
Agent
Suppressing Sampling (not Mainstream CO
To temporarily stop sampling,
in the Setup CO
available.
Selecting Pump 15Min Off again before fifteen minutes have passed resets the timer to fifteen
minutes.
To re-start the pump,
in the Setup CO
Changing CO
2
This refers to CO
1
In the Setup CO
limit.
2
Select etCO
Changing the Apnea Alarm Delay
This determines the time limit after which the monitor alarms if the patient stops breathing.
1
In the Setup CO
Choose the apnea alarm delay time.
2
Safety and effectiveness of the respiration measurement method in the detection of apnea, particularly
WARNING
the apnea of prematurity and apnea of infancy, has not been established.
Deriving Alarms From awRR
1
In the Setup CO
2
In the Setup awRR menu, select Alarms.
3
Choose On to derive alarms from the airway respiration signal or Off to disable them.
At installation, the monitor is configured to automatically apply either
Pressure Saturated (BTPS) or Ambient Temperature Pressure Dry (ATPD). To see
which, go to the Setup CO
In the Setup CO
2
If Helium or N
O is present in the ventilation gas mixture, you must make the
2
appropriate selection.
In the Setup CO
2
anesthetic agent (between 0.0% and 20.0%). If an anesthetic agent is present in the
ventilation gas mixture, you must select the appropriate concentration.
menu, select Pump 15Min Off or use the CO
2
menu, select Pump On.
2
Alarms
specific alarms. See the Alarms section for general alarm information.
2
menu, select
2
Low and choose the low alarm limit.
2
menu, select awRR.
2
menu, select awRR.
2
menu, and scroll down to look at
2
menu, select Gas Corr. and select Helium, N
menu, select
Agent Corr.
)
2
High or imCO
tCO
e
2
15 Monitoring Carbon Dioxide
Body Temperature
HumidtyCorr
O or turn off.
2
and select the concentration of the
Pump Off SmartKey if
2
High and choose the high alarm
2
.
191

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: