DOOR REVERSAL Cont. (For G-10f Coolers Only)
6
7
12
wiring is stretching out from the bottom
7. Remove the hinge axis from the right
bottom hinge, inert it into the left bottom
hinge.
8.Remove door limit from right hinge into
corresponding holes on left hinge
door s
r eserved
h ole,then
g et
t hrough
h inge
a xie,
c onnect
8 Remove door limit from right hinge into corresponding
the
t erminals.
holes on left hinge.
9.Feed the wiring terminals through the
hinge and connect the terminals.
9 Feed the wiring terminals through the hinge and connect
the terminals.
8.clockwise
r otate
t he
l eft
a xie
s leeve
6 0°.
10. Reinstall the torsion rod into the new
10 Reinstall the torsion rod into the new
position of the door axis.
position of the door axis.
11. Set the upper hinge into the torsion
rod at approx a 60°angle. Rotate the hinge
11 Set the upper hinge into the torsion rod at approximately a
to the right counter clockwise aligning the
9.fix
t he
u pper
h inge
i nto
l eft
a xie
s leeve,
t hen
holes in the bracket with the holes on top
60°angle. Rotate the hinge to the right counter-clockwise
of the cabinet.
anticlockwise
r otate
t he
h inge
t o
r ight
p osition
t o
f asten
aligning the holes in the bracket with the holes on top of
it.
the cabinet.
12 Install the limit to the door. Installing sequence—the
12.Install the limit to the door.
Installing sequence:the wave
wave washer—gasket-limit-bolt
washer—gasket-limit-bolt
13 Check to ensure the door is securely attached and
10.assemble
t he
f ront
g rill,
c omplete
t he
r eversible
d oor
functioning properly.
exchange.
14 Attach the front grill to complete the door reversal
process.
G-10f/GCG-10f
of the door left
Innovative DisplayWorks