2-5. H BOARD REMOVAL
• REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after
removing the anode.
• REMOVING PROCEDURES
1 Turn up one side of the rubber cap in
the direction indicated by the arrow A.
• HOW TO HANDLE AN ANODE-CAP
1 Don't scratch the surface of anode-caps with sharp shaped
2 Don't press the rubber hardly not to damage inside of anode-
A material fitting called as shatter-hook terminal is built in the
3 Don't turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or damage the rubber.
2 Using a thumb pull up the rubber cap
firmly in the direction indicated by the
(+BVTP 4 x 16)
3 When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in the
direction of the arrow C.