Page 1
Model No. PFEL2926.0 Serial No. Serial Number Decal QUESTIONS? As a manufacturer, we are com- mitted to providing complete customer satisfaction. If you have questions, or if parts are damaged or missing, PLEASE CONTACT OUR CUSTOMER SERVICE DEPARTMENT DIRECTLY. CALL TOLL-FREE: 1-888-533-1333 Mon.–Fri., 6 a.m.–6 p.m.
IMPORTANT PRECAUTIONS WARNING: To reduce the risk of serious injury, read the following important precau- tions before using the elliptical exerciser. 1. Read all instructions in this manual and all warnings on the elliptical exerciser before using the elliptical exerciser. 2.
To help us assist you, please note the prod- ® uct model number and serial number before contact- ing us. The model number is PFEL2926.0. The serial number is found on a decal attached to the elliptical exerciser (see the front cover of this manual for the location of the decal).
To hire an authorized service technician to assemble the elliptical exerciser, call toll-free 1-800-445-2480. Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Assembly requires the included hex keys and your own adjustable wrench rubber mallet As you assemble the elliptical exerciser, use the drawings below to identify small parts.
Page 6
1. Identify the Stabilizer (9) which has round Endcaps (21) on the ends. While another person lifts the front of the Frame (1), attach the Stabilizer to the Frame with two M10 x 75mm Carriage Bolts (34) and two M10 Nylon Locknuts (33).
Page 7
tion shown, connect the Extension Wire (68) to the Lower Wire Harness (73). Push the Extension Wire (68) and the Lower Wire Harness (73) down into the Frame (1). Slide the Upright (2) onto the Frame. Be careful to avoid pinching the Wires.
Page 8
7. Identify the Left Pedal Leg (11), which is marked with a sticker. Attach the Left Pedal (13) to the Left Pedal Leg with two M8 x 52mm Button Screws (27), two M8 Split Washers (28), and two M8 Washers (71). Attach the Right Pedal (not shown) in the same way.
HOW TO USE THE ELLIPTICAL EXERCISER HOW TO EXERCISE ON THE ELLIPTICAL EXERCISER To mount the elliptical exerciser, hold the handles on the console or the handlebars and step onto the pedal that is in the lowest position. Then, step onto the other pedal.
Page 10
HOW TO USE THE CONSOLE Turn on the console. Note: The console requires four 1.5V “D” batteries (see assembly step 3 on page 6). If there is a sheet of clear plastic on the face of the console, peel off the plastic. To turn on the console, press the increase button or begin pedaling.
Page 11
play is the priori- ty display. The priority display can show the elapsed time, the distance that you have pedaled, your pedaling speed, or the approximate number of calories you have burned. Press the Display button repeatedly until the priori- ty display shows the information that you are most interested in viewing.
Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately. To clean the elliptical exerciser, use a damp cloth and a small amount of mild dish soap. Important: Keep liquids away from the console and keep the con- sole out of direct sunlight.
WARNING: Before beginning this or any exercise pro- gram, consult your physician. This is espe- cially important for persons over the age of 35 or persons with pre-existing health problems. The pulse sensor is not a medical device. Various factors, including the user's move- ment, may affect the accuracy of heart rate readings.
Key No. Qty. Description Frame Upright Left Side Shield Right Side Shield Handlebar Leg Left Handlebar M10 x 74mm Button Bolt Right Handlebar Stabilizer M5 Nylon Locknut Left Pedal Leg Right Pedal Leg Left Pedal Right Pedal Pedal Disc Disc Crossbar Flywheel Side Shield Bracket Drive Belt...
• the MODEL NUMBER of the product (PFEL2926.0) • the NAME of the product (PROFORM 320 elliptical exerciser) • the SERIAL NUMBER of the product (see the front cover of this manual) •...
Need help?
Do you have a question about the PFEL2926.0 and is the answer not in the manual?
Questions and answers