B.1 Warning - Honeywell Sensepoint XCL Installation Manual

B.1 Warning

Description
Warning 1 Calibration Overdue
Warning 3 BLE failure (BLE version only)
Warning 4 Time/date not set (RTC not set) / RTC reset
abnormally
Warning 5 Log memory corrupted (CRC not matched)
Warning 6 Certificate is corrupted or missing certificate
Warning 7 Over-range warning
Warning 8 Under-range warning
B.2 Fault
Description
Fault 1 Internal communication failure
Fault 2 Cell failure
Fault 3 Cell is producing a negative reading
Fault 4 EEPROM is corrupted
Fault 5 MCU operating voltage failure
Fault 6 RAM read/write fault
Fault 7 Flash memory corrupted
Fault 8 Code memory failure
Fault 9 mA output failure (mA output version only)
Fault 10 Supplied voltage failure
Fault 11 Internal HW Fault
Fault 12 Internal SW Fault
Fault 13 Calibration Overdue
44
Troubleshooting
Troubleshooting
Calibrate the unit
Power-cycle the unit. If same warning occurs again, contact
manufacturer
Configure unit time. If same warning occurs again, contact
manufacturer
Power-cycle the unit. Event log might be lost.
Contact manufacturer
Calibrate the unit.
Calibrate the unit.
Troubleshooting
Power-cycle the unit. If same fault occurs again, contact manufacturer
Check the sensor connection. If same fault occurs again, replace sensor
Calibrate the unit
Reconfigure the unit by using mobile app. If same fault occurs again,
contact manufacturer
Power-cycle the unit. If same fault occurs again, contact manufacturer
Power-cycle the unit. If same fault occurs again, contact manufacturer
Reconfigure the unit by using mobile app
Power-cycle the unit. If same fault occurs again, contact manufacturer
Check whether loopback resistor is connected correctly
Power-cycle the unit. If same fault occurs again, contact manufacturer
Power-cycle the unit. If same fault occurs again, contact manufacturer
Power-cycle the unit. If same fault occurs again, contact manufacturer
Calibrate the unit.
Appendix
B