Basic Information - KERN FCE 3K1 Service Manual

1 Basic Information

Grundlegende Hinweise
The device must be repaired only by trained specialist staff or personnel with
professional formation (such as a repair-specialist accredited by law
concerning verification).
The service manual is obligatory for repair work.
After repair, original conditions of the device have to be restored.
Only original spare parts should be used.
Das Gerät darf nur von geschultem oder beruflich ausgebildetem
Fachpersonal (z. B. eichrechtlich anerkannter Instandsetzer) repariert werden.
Die Serviceanleitung ist bindend für Reparaturen.
Das Gerät muss nach erfolgter Reparatur wieder in den Originalzustand
zurückversetzt werden.
Es dürfen nur Originalersatzteile verwendet werden.
2 Digital Auto Calibration Procedure
1. Turn balance on and allow the unit to acclimatize and stabilize for 10 minutes.
2. Press and hold the [TARE] key until the display shows CAL and a weight reading.
The weight reading indicates the correct weight that must be placed on the
weighing pan.
3. Gently place the correct calibration weight on the center on the weighing pan.
4. The display will now show [ F ] and then return to normal operating mode. The
calibration is complete when the display correctly shows the weight that is placed on
the weighing pan while the display has stabilized.
5. Remove the calibration weight and if necessary press the [TARE] key to reset the zero
point.
In case [ E ] is displayed instead of [ F ], this indicates a calibration
procedure error. Turn the scale off and then on and repeat the procedure.
FCE-SH-e-0910 3