Before Each Start-Up; Attach Hose And Accessories; How To Use Telescopic Handle And Wheels For Easier Mobility - Husky 41004 Operator's Manual

4. Open the drain valve fully
(counterclockwise) to permit air
to escape and prevent air
pressure build up in the air tank
during the break-in period.
5. Move the Off/Auto-On switch to
"Auto-On" position. The
compressor will start.
6. Run the compressor for 15
minutes. Make sure the drain
valve is open and there is
minimal air pressure build-up in
tank.
7.
After 15 minutes, close the drain
valve (clockwise). The air receiver
will fill to "cut-out" pressure and
the motor will stop.
The compressor is now ready for use.

Before Each Start-Up:

1. Place Off/Auto-On switch to "Off"
and close air regulator.
2. Turn the regulator knob
counterclockwise until it stops.

Attach hose and accessories

pressure causes a hazardous risk of
bursting. Check the manufacturer's
maximum pressure rating for air tools
and accessories. The regulator outlet
pressure must never exceed the
maximum pressure rating. How to
Start:
1. Turn the Off/Auto-On switch to
"Auto-On" and allow tank
pressure to build. Motor will
stop when tank pressure reaches
"cut-out" pressure.
2. Turn the regulator knob
clockwise until desired pressure
is reached. NOTE: To use the
suggested pressure readings on
the label, turn the regulator knob
clockwise until the needle on the
pressure gauge aligns with the
desired suggested pressure reading
Risk of Bursting.
Too much air
number.
3. The compressor is ready for use.
How to Use Telescopic Handle and
Wheels for Easier Mobility
1. Slide handle out until it locks into
place.
2.
Pull or push unit as shown.
IMPORTANT: This handle is for
pushing or pulling the unit. DO
NOT lift the unit by this handle.
3.
To lower handle, button and push
handle until it snaps into place
for storage.
14