Table of Contents
Advertisement
Advanced
Advanced features of the wireless LAN interface can be
configured in this section.
Settings can be configured for the following—
• AP Isolation n —if you select enable, then each of your
wireless clients will not be able to communicate with each
other.
• Band d —a default setting at 2.4GHz – 802.11g
• Channel l -- 802.11b and 802.11g use channels to limit
interference from other devices. If you are experiencing
interference with another 2.4Ghz device such as a baby
monitor, security alarm, or cordless phone, then change the
channel on your router.
• Multicast Rate e —the rate at which a message is sent to a
specified group of recipients.
• Basic Rate e —the set of data transfer rates that all the
stations will be capable of using to receive frames from a
wireless medium.
• Fragmentation Threshold d —used to fragment packets which
help improve performance in the presence of radio
frequency (RF) interference.
• RTS Threshold (Request to Send Threshold) ) —determines
the packet size of a transmission through the use of the
router to help control traffic flow.
• DTIM Interval l —sets the Wake-up interval for clients in
power-saving mode.
• Beacon Interval l —a packet of information that is sent from a
connected device to all other devices where it announces
its availability and readiness. A beacon interval is a period
of time (sent with the beacon) before sending the beacon
again. The beacon interval may be adjusted in milliseconds
(ms).
4-Port Wireless Ethernet Router
User Manual
Version 1.0
46
Advertisement
Table of Contents
