Advertisement
M1
Turns on the speaker during dial calling and turns it off
during reception of a carrier from the destination
modem.
M2
Sets the speaker to on at all times.
M3
Turns on the speaker after a dial number is sent and
turns it off after carrier reception.
Factory setting value: M1
ATOn
This command is used to return the modem to the online
state again when the modem is put from the online state to
the command state (in the &D1 mode) using an escape
sequence or ER signal.
00
Returns the modem to the online mode.
ATP
This command sets the current dial to a pulse dial.
Parameter P can be omitted using the subsequent dial
command.
* This command is written in non-volatile memory by &W.
[Related parameters]
D,T
29
Advertisement
