Dell Edge Gateway 3002 Installation And Operation Manual page 54

7. Run the command to pair the Bluetooth keyboard.
$pair <MAC address of Bluetooth keyboard>
8. Enter the PIN code on the Bluetooth keyboard, if needed.
9. Run the command to trust the Bluetooth keyboard.
$trust <MAC address of Bluetooth keyboard>
10. Run the command to connect the to the Bluetooth keyboard.
$connect <MAC address of Bluetooth keyboard>
11. To quit the bluetoothctl console.
$quit
Switching between WLAN and Bluetooth modes
1. Unload the WLAN/BT driver.
$ modprobe -r ven_rsi_sdio
2. Adjust the mode in /etc/modprobe.d/rs9113.conf
3. Reload the WLAN/BT driver.
$ modprobe ven_rsi_sdio
4. Verify the operation mode. Refer to the table for operating mode values.
$ cat /sys/module/ven_rsi_sdio/parameters/dev_oper_mode
Table 10. Operating-mode values for WLAN and Bluetooth
Operating mode value
1
1
13
14
5
6
Bluetooth Serial Port Profile (SPP)
Assumptions for MAC addresses of each BT adapter:
• BT MAC(MYCLIENT): XX:XX:XX:XX:XX:XX
• BT MAC(MYSERVER): YY:YY:YY:YY:YY:YY
1. Pre-requirements (for Debian-only, not required on Ubuntu Core OS).
sudo apt-get install bluez bluez-tools
2. Prepare to pair MYSERVER and MYCLIENT
$ sudo bluez.bluetoothctl -a
[bluetoothctl]# power on
[bluetooth]# discoverable on
[bluetooth]# scan on
[NEW] Device XX:XX:XX:XX:XX:XX MYCLIENT
[bluetooth]# scan off
3. Pair with each other. As of Bluetooth v2.1, Secure Simple Pairing is a requirement, and offers three methods of pairing devices,
which are applicable on the Dell Gateway 3000 series:
• Just Works
54
WiFi station
X
X
X
BT/BLE modes
supported
N/A
N/A
Dual (BT classic and
BTLE)
Dual (BT classic and
BTLE)
BT Classic
BT Classic
softAP
X
X
X
Clients supported by
softAP
N/A
32
N/A
4
N/A
32