Table of Contents
Advertisement
Malfunction table
Problem
The appliance does not work.
The current time is not shown in
the display.
The oven does not heat up or the
type of heating selected cannot be
set.
The oven does not heat up. A small
square lights up in the temperature
display.
”‰ appears in the display.
Error messages with “
Error message
“‹‚‚
Possible cause
Blown fuse.
Power interruption.
Type of heating not
identified.
The oven is in demo
mode.
Automatic switch off
has been activated.
The oven stops
heating.
If an error message appears in the display with “,
press the 0 button. This clears the error message.
You may then need to reset the clock. If this fault
occurs again, call the after sales service.
You can take remedial action yourself if the following
error message is displayed.
Possible cause
A button has been
pressed for too long.
d
Risk of electric shock.
Improper repairs are dangerous. Repairs may only be
carried out by one of our experienced after sales
engineers.
Notes/remedial action
Look in the fuse box and check that the
fuse is in working order.
Reset the clock.
Make the settings again.
Switch off the circuit breaker in the fuse
box, then switch it back on after at least
20 seconds. Within the next 2 minutes,
press and hold the D button for
4 seconds until the square disappears
from the display.
Press any button.
Notes/remedial action
Check that all the buttons are clean.
Press all buttons individually. If the error
message remains, please contact the
after sales service.
41
Advertisement
Table of Contents
