AEG 49176IW-MN User Manual page 35

Problem
comes on the hob dis-
play.
comes on the hob dis-
play.
comes on the hob dis-
play.
comes on the hob dis-
play.
comes on the hob dis-
play.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The core temperature sensor
does not operate.
It takes too long to cook the
dishes or they cook too
quickly.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows an error
code that is not in this table.
Possible cause
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on the
zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too small
for the zone.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The automatic switch-off is
activated.
The lamp is defective.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
The temperature is too low
or too high.
You left the dish in the oven
for too long.
There is an electrical fault.
ENGLISH
Remedy
Deactivate the hob and acti-
vate it again.
Refer to "Hob - Daily use"
chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hob - Hints and
tips" chapter.
Use cookware with correct
dimensions.
Refer to "Hob - Hints and
tips" chapter.
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Replace the lamp.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
Adjust the temperature if
necessary. Follow the advice
in the user manual.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Deactivate the appliance
with the house fuse or the
safety switch in the fuse box
and activate it again.
If the display shows the error
code again, contact the Cus-
tomer Care Department.
35