Attaching The Elite Slice To A Mounting Device - HP Elite Slice Hardware Reference Manual

To connect to an AC outlet:
1. Connect the power cord to the AC adapter and the AC outlet.
IMPORTANT:
shipped with the Elite Slice.
2. Connect the AC adapter to the power connector on the rear of the Elite Slice.
If you have an HP monitor with a charging port that can supply at least 60 W, you may connect the Elite Slice
to the monitor instead of an AC outlet.
1. Disconnect Slice from AC power.
NOTE:
AC power.
2. Connect one end of a US Type-C cable (purchased separately) to a rear USB Type-C port on the Elite Slice.
3. Connect the other end of the cable to a charging port on an HP monitor.

Attaching the Elite Slice to a mounting device

If the VESA plate is connected, the Elite Slice can be attached to a monitor, wall, or desk in either of two
mounting positions:
Vertical
●
Horizontal with all cables attached to the rear of the computer and hanging straight down
●
To mount the Elite Slice:
1. Connect all modules except the VESA plate.
2. Use the four screws provided with the VESA plate to attach the VESA plate to the monitor or other
surface.
If the Elite Slice is to be mounted horizontally, be sure to position the VESA plate with the quick release
latch facing down. All cords and cables should be hanging straight down from the connectors.
12 Chapter 2 Setup
When connecting the Elite Slice to an AC outlet, you must use the HP adapter that
If the Elite Slice is connected to both a powered port and an AC outlet, the Elite Slice will use the