Starting The Unit And Handling - Kärcher CW 100 Manual

Table of Contents

Advertisement

English
Note: We recommend using our microfilter mounting kit in addition to
the paper filter bag (Order no. see 4. Accessories). BIA category C,
Filtration efficiency always higher than 99.9 %. It allows particularly fine
dusts to be sucked off which are damaging to health. The micro filter
should be changed when the suction performance is insufficient even
after new paper filter bags have been fitted.
3.1 Connect the upper section of the vacuum
cleaner to the brush head
Unscrew both fastening screws from the upper section of the
vacuum cleaner before assembly.
Push the upper section of the vacuum cleaner upright onto the
brush head. Then insert the two aluminium sections into the
grooves provided on the upper section of the vacuum cleaner.
Fasten with screws. Tighten screws firmly. <Figure 2>
Connect the hose to the brush head and upper section of vacuum
cleaner. Plug the connecting cable with connector into the socket
on the upper section (plug must audibly click into place). <Figure 3>
3.2 Storing and removing cable
The vacuum cleaner's power cable can be wounded up around
the upper and lower cable clips. The entire cable can be easily
removed by turning the lower cable clip.
3.3 On and off positions
The brush head has a pivot latch which locks the unit in the
upright off position. To operate, tread on the latched pedal and
tip the vacuum cleaner backwards. <Figure 4>
Caution: do not drive the rotating brushes over the connecting
cable. Carry the unit over steps and high thresholds.
3.4 Working with the hand pipe <Figure 5>
Switch the unit on via the ON/OFF switch
Please note: The carpet brush switches on automatically once
the hand pipe with handle is firmly located in the motor housing.
Please check.
If the hand pipe with handle is pulled out of the motor housing
for vacuuming, the carpet brush switches off automatically.
The suction hose's elasticity means that the effective working
radius can be increased.
The crevice and upholstery nozzle can be attached to the end
of hand pipe.
10

3. Starting the unit and handling

5.956-723
Figure 2
Figure 3
Figure 4
Figure 5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents