Required Tools; Package Contents - Lenovo RackSwitch G7000 Installation Manual

Redundant power supply

Table of Contents

Chapter 2. Installing and removing the redundant power

supply

This chapter describes how to install and remove the redundant power supply in the following racks:

• Installing and removing the redundant power supply in a standard equipment rack

• Installing and removing the redundant power supply in a Lenovo System x or IBM Power rack

Before installing the redundant power supply

Locate and record the important product information about the G7000 unit in the following table. The

identification label (bottom of unit) contains the product name, serial number, and part number for the G7000

unit. The following illustration is an example of the serial number label. It may differ slightly from the G7000

identification labels.

After installed most of the identification labels are hidden from view and require removing the unit in order to

relocate them.

Attention: This product information is required to register your product, place a service call, and replace the

unit.

After the redundant power supply is installed most of the labels are hidden from view and require removing

the unit in order to relocate them.

Record this information below and print this page and keep it in a safe place for future reference. You will

need this information when you register the redundant power supply or open a service call. You can register

the redundant power supply at

Product name

Serial number

Part number

Required tools

You need the following tools or equipment to install the redundant power supply:

• Standard flat-blade screwdriver

• #2 Phillips screwdriver

• Electrostatic discharge wrist strap

Note: The illustrations in this document might differ slightly from your hardware.

http://www.ibm.com/support/mysupport/

Lenovo RackSwitch G7000 Redundant Power Supply

_____________________________________________

Table of Contents