Defi Nition Of Analog Signal By Remote Controller - Mitsubishi Electric PAC-IF031B-E Installation Manual

10. Defi nition of analog signal by remote controller (Required only for ANALOG TEMP. system)
Set following 2 parameters to assign the target temperature value to analog signal figures.
(1) Press
INITIAL SETTING
(2) [DISPLA
Y ]
AD INPUT
HEATING
Press button
MODE
AD INPUT
Set flow temp. for No.1 and No.2 with
HEATING
AD INPUT
Set flow temp. for No.1 and No.2 with
COOLING
Press button
ON/OFF
♦ In order to let FTC2 memorize set parameters
Make sure to press
CIR.WATER
If you press
ON/OFF
making any change.
TEMP.
RG79D525H01_EN.indd 33 RG79D525H01_EN.indd 33
button for 3 seconds to activate this setting mode.
AD INPUT
COOLING
to switch to the next parameter setting.
to switch alternately. (The blinking figure can be changed.)
button before exit from ANALOG SIGNAL ADJUST mode.
button before pressing
CIR.WATER
˚C
˚C
ON/OFF
FLOW TEMP.
[TEMP] buttons ( and ) .
[TEMP] buttons ( and ) .
button in ADJUST mode, you can exit from this mode without
No.2
No.1
4mA --------------------------20m
ANALOG
SIGNAL
1V ------------------------------ 5V
0V ----------------------------- 10V
33
2009/04/10 9:25:13 2009/04/10 9:25:13