Makita HM1140C Instruction Manual page 7

Bit angle
The bit
can be secured at
12
different angles.
To
change the
bit
angle,
slide
the change
ring forward, then turn the change ring to change the bit angle. At the desired angle, slide
the change ring back to the original position. Then turn the change ring slightly so that the
bit will be secured in place with a little click
To start the tool, push the "ON I" button on
the left side of the tool. To stop the tool,
push the "OFF 0" button on the right side of
the tool.
I
Change ring
"ON I"
Side handle (auxiliary handle)
The side handle can be swung
360'
on the
vertical and secured at any desired position.
It also secures
a t
eight different positions
back and forth on the horizontal. Just
loosen the clamp nut to swing the side han-
dle to a desired position. Then tighten the
clamp nut securely.
Switch action
CAUTION:
Before plugging in the tool, always check to see that the tool is switched off.
7